Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

White mascot in gold headphones holding 3.5mm, optical and RCA plugs over a desk of small audio boxes and cables.

Audio connector and cable types

In most systems, the sockets two components share decide which audio connector you use: RCA or XLR between hi-fi boxes, a 3.5mm, 6.35mm or 4.4mm balanced plug for headphones, and USB, optical or coaxial for digital links. Balanced connections earn their place over long runs or when a system hums.

12 terms Updated

Analog connections

Between hi-fi boxes, analog audio travels at line level on one of two connectors. Which one you use matters less over a meter of cable than its price suggests, and more once a system starts to hum.

RCA
RCA is the round, single-pin analog connector used in pairs, one red and one white, to carry a stereo line-level signal between hi-fi components. It is unbalanced, cheap and everywhere, and the same plug carries a coaxial digital signal.
Each stereo RCA link uses a pair of sockets, so the number of RCA input pairs on an amplifier is the number of analog sources it takes without a switch box.
XLR
XLR is the locking three-pin connector used for balanced analog connections between hi-fi components and in professional audio. A four-pin version carries a balanced signal to headphones from a desktop amplifier.
On DACs, XLR outputs are commonly rated at about 4 V against 2 V for RCA, so expect to turn the volume down when a system moves from RCA to XLR.
Balanced vs single-ended
A balanced connection carries the signal on two matched conductors and responds only to the difference between them, so noise picked up equally by both cancels. A single-ended connection uses one signal wire and a shared ground; it is simpler and fine for short cables.
Check which kind a product means: balanced line outputs on XLR and a balanced headphone socket are separate features, and a DAC or amplifier can have either without the other.
Ground loop
A ground loop forms when two connected components are also earthed by separate routes, usually through their mains plugs, so a small current flows round the loop through the signal cable’s shield. The result is a steady hum at the mains frequency.
Optical and balanced XLR are the two connections here that can stop loop hum at the signal end, optical by carrying no ground and XLR by rejecting the hum.

Headphone plugs

Three plug sizes cover almost every wired headphone. Size alone does not tell you whether a connection is balanced; the number of contacts does.

3.5mm
The 3.5mm jack is the small round analog audio connector on phones, laptops and many portable players and headphones. It carries a stereo signal on a single plug.
Spec sheets and shops may call it a mini jack or 1/8 inch plug; both mean the same stereo plug, and TRRS marks the four-contact headset version.
6.35mm
The 6.35mm jack, also called a quarter-inch plug, is the large headphone connector found on desktop amplifiers, receivers, mixers and musical instruments. As a headphone connector it is single-ended and carries the same stereo signal as a 3.5mm plug, on a sturdier body.
On a headphone amplifier with two or more sockets, the 6.35mm one is normally the single-ended output, with balanced duties left to a 4.4mm or four-pin XLR socket beside it.
4.4mm balanced
The 4.4mm balanced jack is a five-contact headphone plug, 4.4 millimeters across, that carries separate positive and negative signals for each ear. It is the usual balanced output on portable players and desktop amplifiers.
Its five contacts show as four insulating bands on the plug, the quickest way to tell it from a three-contact 3.5mm or 6.35mm plug in a drawer of cables.

Guides that go further

Other topics