Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Connectors & cables

Ground loop

Also called ground loop hum, earth loop, mains hum

A ground loop forms when two connected components are also earthed by separate routes, usually through their mains plugs, so a small current flows round the loop through the signal cable’s shield. The result is a steady hum at the mains frequency.

The earth connection at each outlet sits at a slightly different voltage, because the wiring to it has resistance and carries small leakage currents. Connect two earthed devices with an unbalanced RCA cable and its shield becomes part of a loop between them. The current in the loop adds a small voltage to the signal, and the amplifier amplifies it along with the music.

The usual causes are a cable TV or antenna lead, which brings a separate earth into the system; a computer connected by USB to an earthed amplifier; and a powered subwoofer plugged into a different wall outlet from the rest. A turntable that hums because its ground wire is not connected has the opposite fault, a missing ground, which the phono stage entry covers.

Never cure a ground loop by removing the earth from a mains plug, whether with a two-pin adapter, a “cheater” plug or by cutting off the earth pin. That earth is a safety connection: if a fault makes the metal case live, it carries the current away and trips the breaker or blows the fuse. Without it, anyone who touches the case, or a cable connected to it, can receive a dangerous electric shock. A ground-lift switch built into some equipment is different, because it separates only the signal ground and leaves the safety earth in place.

Common questions

Is a ground loop dangerous?

The hum itself is not: the loop current is small and the voltages involved are tiny. The danger lies in the wrong fix. Removing the protective earth of a mains plug, with an adapter or by cutting the pin, can leave a metal case live after a fault, with a risk of electric shock or fire. Break the loop on the signal side instead, and have an electrician check the wiring if the hum persists.

How do you fix a ground loop hum?

First plug every component into one power strip so they share an earth point; that alone often cures it. Then unplug signal cables one at a time to find which one completes the loop, and break it there: a balanced connection, an optical digital link in place of USB or coaxial, a ground loop isolator in the line-level cable, or an isolator on the antenna lead. Never remove a mains earth.

Do ground loop isolators affect sound quality?

A good one barely does; a cheap one can. Most isolators are small audio transformers, and inexpensive ones can lose some of the deepest bass and add distortion when the signal is large. Better units with larger transformers measure close to flat across the audio band. An isolator treats the symptom, so finding and removing the loop is the cleaner answer where it is practical.

Can a ground loop damage speakers?

Rarely. Ground loop hum is a low-level tone at 50 or 60 Hz, far below the power that harms a driver, though at high volume a loud hum keeps a woofer or subwoofer working continuously. The more common risk is a loud thump when cables are plugged in or pulled out with the system on, which can damage tweeters. Switch the amplifier off, or turn it down, before changing connections.

Related terms