Line level
Also called line out, line input, line-level signal
Line level is the standard signal voltage passed between audio components, stronger than a microphone or turntable signal and weaker than a speaker signal. Home equipment works at a nominal −10 dBV, about 0.316 V; professional equipment at +4 dBu, about 1.23 V.
A DAC, CD player, streamer, tuner or phono stage sends line level to an amplifier or preamp. Below it sit a moving magnet cartridge at 3 to 5 mV and a microphone at a few millivolts; above it, an amplifier putting 100 W into an 8 Ω speaker swings about 28 V.
The nominal figure is a working level, not a ceiling. A CD player or DAC reaches about 2 V at full scale by long convention, and many DACs give about 4 V from their balanced outputs. Music peaks well above its average, so line inputs are built to accept more than their nominal level, and an amplifier input designed around 316 mV usually copes with a 2 V source. The higher output of a DAC is one reason amplifier volume knobs usually sit low in their travel.
Professional +4 dBu sits about 12 dB above consumer −10 dBV. Connect studio equipment to a home input, or the reverse, and the level arrives about 12 dB too hot or too quiet; a switchable input, an output setting or an inline attenuator puts it right. The figures are standard published values; individual products sit either side of them.
Common questions
Is line level balanced or unbalanced?
Either. Line level describes the voltage; balanced or unbalanced describes the wiring that carries it. Home equipment mostly sends −10 dBV over unbalanced RCA cables and studio equipment +4 dBu over balanced XLR or TRS, but many home DACs and preamps offer balanced XLR outputs too. An XLR cable can carry line level, microphone level or AES3 digital audio, so the socket alone does not tell you which.
Does a line-level source need a preamp?
It needs a volume control, not more gain. An integrated amplifier or receiver already has one, and a DAC or streamer with a variable output can feed a power amplifier or active speakers directly. A fixed line output connected to a power amplifier with no volume control plays at full level, loud enough to damage speakers and hearing. A turntable without a built-in phono stage is not a line-level source.
Can a line output drive headphones?
Not properly. A line output is designed to feed an input of 10 kΩ or more, and a 32 Ω headphone asks for far more current than many line stages can supply, so the sound may be quiet, distorted or thin in the bass. Many line outputs are also fixed at full level with no volume control, which can be dangerously loud in headphones. A headphone amplifier is the right connection.
Is line level high or low impedance?
Both, at different ends. Line outputs have a low output impedance, typically from about 100 Ω to 1 kΩ, while line inputs are high, often 10 kΩ to 100 kΩ, so the input draws little current and the level hardly drops. This is called bridging. Older studio systems matched 600 Ω at both ends, a habit inherited from telephone lines; modern professional equipment bridges too.
Can you split a line-level signal?
Yes. A Y-cable feeding two inputs works well over short runs: two 10 kΩ inputs in parallel make 5 kΩ, which a normal line output drives easily. It is a common way to send one DAC to both a headphone amplifier and a power amplifier. The usual problem is hum, because the two destinations can form a ground loop. A powered distribution amplifier, which buffers each output separately, is the reliable route for long runs.