Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Amps, DACs & sources

Power amplifier

Also called power amp, stereo power amplifier

A power amplifier raises a line-level signal to the voltage and current that passive speakers need. Most have no volume control or input selector, so they take their signal from a preamp or a source with its own volume control.

A power amplifier has fixed gain, typically around 26 to 30 dB, so how loud it plays is set by the voltage arriving at its input. The figure to look for is input sensitivity: the input voltage that drives the amplifier to full power, often between about 1 and 2 V. A DAC or preamp that reaches 2 V can therefore push most power amplifiers into clipping, and the volume control in front of the amplifier is what stops it.

They come as stereo, as multichannel for home theater, or with one channel per box, the monoblock. The power section of an integrated amplifier is the same circuit with a preamp in front. Many stereo models can be bridged, combining both channels into one with more power, so that two of them work as a pair of monoblocks. Output stages are Class AB, Class D, Class A or tube, and the specifications to read are power output into your speakers’ impedance, damping factor and noise.

Watts buy less loudness than the numbers suggest. Doubling the power adds only 3 dB, a modest step, so a 200 W amplifier plays about 3 dB louder than a 100 W one into the same speaker before clipping, not twice as loud. At normal home listening levels with typical speakers, the average power drawn is commonly estimated at a watt or less; the rest is headroom for peaks.

Common questions

Do power amps have volume control?

Most do not. A power amplifier is meant to sit after a preamp that sets the level. Some have input level knobs, and professional amplifiers usually have one per channel; those are set once to match the source and then left alone, not used as a daily volume control. Turn them down before connecting anything, since a source at full output into an amplifier at full gain is loud enough to damage speakers.

Can you connect a DAC directly to a power amplifier?

Yes, if the DAC has a volume control that acts on its line output. Without one, its fixed output of about 2 V drives most power amplifiers to full power, which is dangerous for speakers and for ears. With one, start at minimum and raise it with music playing. If all your sources are digital, a DAC with a volume control and a remote can replace a preamp entirely.

How do you connect a power amplifier?

With everything switched off, run RCA or XLR interconnects from the preamp outputs to the amplifier inputs, then speaker cable from each amplifier channel to its speaker, red terminal to red and black to black. Check that no stray strand of wire bridges the two terminals, which can short the output. Switch on the sources and preamp first and the power amplifier last, and switch off in reverse order, which keeps thumps out of the speakers.

Do power amplifiers sound different?

Below clipping, competent power amplifiers measure very close to one another, and with levels matched to a fraction of a decibel they are hard to tell apart. Differences show at the edges: a small amplifier clipping on peaks, a tube amplifier’s high output impedance changing the tonal balance of a speaker whose impedance swings, or hiss through very sensitive speakers. Many listeners report differences beyond those, and the argument shows no sign of tiring.

Related terms