Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Amps, DACs & sources

Monoblock

Also called monoblock amplifier, monobloc, mono amplifier

A monoblock is a power amplifier with one channel in its own chassis. A stereo system uses a pair, one for each speaker, so each channel gets its own power supply and can sit close to the speaker it drives.

Each monoblock takes one line-level input, left or right, from a preamp and drives one speaker. Separating the channels gives each its own transformer and supply, so a loud bass note in one channel cannot draw down the supply the other is using, and it reduces crosstalk between channels inside the amplifier. It also frees the layout: the amplifiers can sit beside the speakers on short speaker cables, with long interconnects, often balanced XLR, running back to the preamp.

The practical case is usually power. A single chassis has room for one large transformer and one set of heatsinks, and splitting the job into two boxes makes very high outputs easier to build and to cool. The cost is two of everything: cases, transformers, mains cables and shelf space.

A pair of monoblocks is not automatically better than a good stereo power amplifier. The stereo amplifier already keeps crosstalk far below the level of the music, and its shared supply is sized for both channels driven at once. Whether the differences that remain can be heard has not been settled.

Common questions

How do you set up monoblock amplifiers?

Place one amplifier near each speaker, on a solid surface with space around it for ventilation. Run the preamp’s left output to the left monoblock and the right output to the right one, and label the cables, since swapping them swaps the stereo image. Keep the speaker cables short. Plugging both into the same mains block makes ground-loop hum less likely. Switch them on after the preamp and off before it.

How many monoblocks do I need?

One per speaker channel. A stereo pair of speakers needs two, one for each side. Bi-amping, with separate amplifiers for the woofer and tweeter sections of speakers that have separate terminals for each, needs four. A home theater system needs one per channel, which is why multichannel amplifiers are more common there. A single monoblock is also a sensible way to power a passive subwoofer, since bass is usually mono.

Why are monoblock amplifiers so expensive?

Because a pair is two complete amplifiers. Each needs its own case, transformer, power supply, sockets and mains switch, so a pair uses close to twice the parts of a stereo amplifier with the same power per channel, and the parts that cost most, the transformer and the metalwork, are exactly the ones duplicated. Monoblocks are also usually made in small numbers for the top of a maker’s range. Check whether a price is per amplifier or per pair.

What does a monoblock amp do in a car?

It powers the subwoofer. In car audio a monoblock is a one-channel amplifier, usually Class D, built to drive one or more subwoofers at low impedance, often rated for 2 Ω or 1 Ω so that several voice coils can be wired together. A four-channel amplifier runs the door and dash speakers. Many car systems use both: a four-channel amplifier for the main speakers and a monoblock for the bass.

Related terms