Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Specs & measurements

Gain

Also called voltage gain, gain switch, gain staging

Gain is how much an amplifier or preamp multiplies the signal it is given, usually stated in decibels of voltage. It sets how far the volume knob turns to reach a given loudness, not how much power the amplifier can deliver.

0 dB−20−40output levelknob at minimumhalfmaximummaximum output: the same on both settingshigh gainlow gain, 6 dB lower
Gain sets how loud an amplifier is at a given knob position, not how much it can deliver. In this illustrative chart, with the same input signal, the high-gain setting is 6 dB louder (double the voltage) at every position until both reach the same maximum output; turning further only adds clipping.

An amplifier with 6 dB of gain doubles the input voltage; one with 20 dB multiplies it by ten. Many headphone amplifiers have a gain switch with two or three settings. The switch does not raise the maximum output, which the power supply and output stage fix; it changes how much input it takes to get there. Turning the gain up makes an amplifier louder at any given knob position, which is easily mistaken for more power, and frequently is.

Power amplifiers have fixed gain, typically 26 to 30 dB. At 26 dB the input is multiplied by 20, so 1.4 V in gives about 28 V out, which is 100 W into 8 Ω. Fed directly from the 2 V line output a DAC produces at full scale, that amplifier would clip before the source reached its maximum, one reason a volume control sits between them. See power output for the arithmetic.

Gain staging means setting each stage in a chain so that none clips and none runs so low that its own noise becomes audible. In a hi-fi system the usual trap is too much gain rather than too little: every decibel of gain beyond what the loudest listening needs also raises the noise floor and costs headroom in the stages that follow.

Common questions

What is the difference between gain and volume?

Gain is the fixed amount a stage amplifies; volume is a variable control, usually an attenuator, that sets how much of the result reaches the output. On a headphone amplifier the gain switch sets the range and the knob picks a point within it. In recording, the input gain or trim sets the level going into the converter, and the fader sets the level in the mix afterward.

Does gain affect sound quality?

Not when it is set sensibly. Too much gain amplifies noise along with the music, can push later stages into clipping and leaves the volume knob working in its first few degrees. Too little leaves quiet recordings short of level. Between those, a competent amplifier measures much the same on any setting, with the difference showing mainly as a few decibels of extra hiss on high gain, audible only with sensitive IEMs.

Should I use high or low gain on a headphone amp?

Use the lowest setting that reaches your loudest listening level with the knob comfortably short of maximum. With sensitive IEMs that is nearly always low gain: on high, a normal level can sit in the first few degrees of the knob, where analog volume controls track unevenly and one channel may be louder. Turn the volume down before changing the setting, since the level can jump sharply.

Does gain distort audio?

Gain itself does not; running out of room does. A stage distorts when the signal it is asked to produce exceeds its maximum, and the tops of the waveform are cut off. In software the limit is 0 dBFS: raising a track by 6 dB when its peaks already reach −3 dBFS clips them by 3 dB. In analog gear, too much gain early in a chain can overload the stage that follows.

Related terms