Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Speakers

Crossover

Also called crossover network, crossover frequency, crossover point

A crossover splits an audio signal by frequency so each driver gets only the range it can play: bass to the woofer, treble to the tweeter. It is passive, inside the speaker after the amplifier, or active, splitting the signal before amplification.

−24−120dB20 Hz1001k10k20kwoofertweetercrossover 2.5 kHzeach −6 dBboth together: flat
A two-way crossover at 2.5 kHz: the woofer is rolled off above it and the tweeter below it, each at 24 dB per octave and 6 dB down at the crossover point. There the two are in phase, so their outputs add up to a flat response.

A passive crossover is a circuit board of capacitors, inductors and resistors inside the cabinet, between the amplifier’s output and the drivers. It rolls each driver off above or below the crossover frequency, which in a typical two-way bookshelf speaker sits somewhere around 1.5 to 3 kHz. The filters slope at 6, 12, 18 or 24 dB per octave; steeper slopes keep more bass out of a tweeter that cannot handle it. The network also evens out differences in the drivers’ level and response, so designing it is a large part of how a speaker is voiced.

An active crossover does the split before amplification, on the line-level signal, with analog filters or digital processing, and gives each driver its own amplifier channel. That is the design of most active speakers: no power lost in large inductors, filters as precise as the designer likes, and freedom to correct each driver separately. The cost is more amplifier channels.

A system with a subwoofer has a crossover too. The subwoofer, or an AV receiver, sends the lowest notes to the subwoofer and, where it can, filters them out of the main speakers so both are not playing the same range into the room.

Each extra crossover point trades one problem for another. A three-way speaker gives each driver a narrower job, and adds one more place where two drivers have to blend. The same trade applies to multi-driver and hybrid IEMs.

Common questions

Do speaker crossovers wear out?

Some parts do. Inductors and resistors last indefinitely, but electrolytic capacitors dry out and drift in value over decades, which dulls the treble or changes the balance between drivers. Film capacitors are far more stable. Replacing the capacitors, called recapping, is a common job on speakers from the 1970s and 1980s. Fit parts of the original value; changing values changes the speaker’s voicing.

What should a subwoofer crossover be set to?

80 Hz is the usual starting point, and the THX recommendation for home theater. In a stereo system, set it near where the main speakers start to roll off: higher for small bookshelf speakers, lower for floorstanders that reach 40 Hz. Then adjust by ear and by moving the subwoofer. If the receiver handles bass management, set the subwoofer’s own crossover to its maximum or bypass it.

Are speaker crossovers necessary?

For any speaker with more than one driver, yes. Without a crossover the tweeter receives the full bass signal, which it cannot reproduce and which can burn out its voice coil, and the woofer plays treble it disperses badly. Full-range single-driver speakers manage without one, at the cost of limited bass, treble or both. A subwoofer always needs one, built in or in the receiver.

How is a speaker’s crossover frequency chosen?

From the limits of the two drivers. The tweeter needs to stay well above its own resonance, commonly at least an octave, or it distorts. The woofer starts to beam, narrowing its dispersion, once the wavelength approaches its cone diameter, roughly 2 to 3 kHz for a 6.5 inch driver. Designers pick a point between the two where both are comfortable, then check it with measurements.

Related terms