Woofer
Also called bass driver, mid-woofer, mid/bass driver, low-frequency driver
A woofer is the larger speaker driver that plays the bass. In a two-way speaker it also covers the midrange up to the crossover, usually somewhere around 1.5 to 3 kHz, and is then often called a mid-woofer or mid/bass driver.
A woofer is a cone, a voice coil and a magnet: the coil moves in the magnet’s gap and drives the cone, which is held by a flexible surround at its rim and a corrugated spider behind. Cones are made of paper, polypropylene, aluminum, woven aramid fiber or composites, each a different balance of stiffness, weight and internal damping.
Size sets how much air a woofer can move, and moving air is what bass needs, so a larger cone or a longer throw plays louder in the low end. Size does not on its own decide how deep a speaker goes; the cabinet volume and its tuning, sealed or ported, decide that, so a small woofer in a large, low-tuned box can reach lower than a bigger one in a small box. Large cones struggle at the top of their range instead, because they beam once the wavelength nears their diameter.
When choosing speakers, compare the maker’s low-frequency limit with the tolerance that goes with it: a figure such as 45 Hz means little without the decibel limit attached. Where a subwoofer is used, the main speakers’ woofers hand over their lowest octave or so and play the rest.
Common questions
What is the difference between a woofer and a subwoofer?
A woofer is a driver; a subwoofer is usually a whole speaker. Woofers sit in ordinary speakers and play from the bass up into the midrange. A subwoofer is a separate cabinet with a large driver, and usually its own amplifier, that plays only the lowest notes, typically below about 80 to 120 Hz, and leaves the main speakers to handle everything above.
What is the difference between a woofer and a tweeter?
Size and range. The woofer is the large cone, usually at the bottom of a speaker, and plays the bass and, in a two-way design, the midrange too. The tweeter is the small dome, usually above it, that plays the treble. A crossover splits the signal between them. A speaker needs both because no single driver can be large enough to move bass and small enough to spread treble evenly.
What is the difference between a woofer and a midrange driver?
In a three-way speaker, the woofer plays only the bass, up to a crossover usually a few hundred hertz up, and a smaller midrange driver takes over from there to the tweeter. In a two-way speaker there is no separate midrange: the woofer plays both and is called a mid-woofer. Splitting the range lets each driver work where it performs best, at the cost of one more crossover point.
Why do some speakers have two woofers?
For more output, or to give each woofer a different job. Two woofers have twice the cone area, so the speaker reaches the same level with less excursion and less distortion. In a 2.5-way design both play bass, but only one continues up into the midrange. Horizontal center-channel speakers put one woofer each side of the tweeter to keep the cabinet low enough to sit under a TV, a layout that narrows their spread to seats off to the side.