Counterweight
Also called tonearm counterweight, counterbalance
The counterweight is the round weight on the back of a tonearm. It first balances the arm so it floats level, then, moved forward past that point, sets the stylus’s downward tracking force, usually read from a numbered ring on its front.
A pivoted tonearm works like a seesaw. The cartridge and headshell sit at one end, and the counterweight is turned or slid along the rear stub until the two sides balance. Moving it further toward the pivot leaves the front end heavier, and that surplus is the tracking force. The numbered ring only measures movement away from the balance point, so its reading means nothing until the arm has been balanced and the ring set to zero.
Counterweights come in different masses for different cartridges, and makers sell heavier and lighter ones for cartridges at either extreme. Many counterweights sit on a rubber sleeve that decouples them from the arm tube, and some hang low, near the height of the record, to keep the arm stable.
Not every arm sets force with the counterweight. On arms with dynamic balance, the counterweight only balances the arm, and a spring then applies the tracking force, read from its own dial.
Common questions
What should a turntable counterweight be set to?
To the tracking force your cartridge maker recommends, not a number copied from another turntable. For most hi-fi cartridges that is somewhere between about 1.5 and 2.5 grams, while many DJ cartridges are designed for more. The figure belongs to the cartridge, so it changes when you fit a new one, and the anti-skate setting should follow it.
What happens if the turntable counterweight is too heavy?
If it is simply set too far back, the arm floats up or presses too lightly, and the stylus mistracks and wears the groove. If the weight itself is too heavy for a light cartridge, it reaches the front of its travel before the arm balances. Makers offer lighter counterweights for this, and a small headshell weight is the usual workaround. A heavy cartridge has the opposite problem and needs a heavier counterweight.
Which way round does a turntable counterweight go?
On most decks, with the numbered ring facing the front, toward the cartridge, threaded onto the rear stub of the arm. Push it on gently and turn until the thread catches; forcing it can strain the arm’s bearings, so steady the arm tube with your other hand. Some arms take the weight on a plain shaft with a locking screw instead of a thread. Then balance the arm and set the force.