Anti-skate
Also called anti-skating, skating compensation, bias compensation
Anti-skate is a small outward force applied to a pivoted tonearm to counter skating, the pull that draws the stylus toward the center of the record. Set correctly, it keeps the stylus pressing evenly on both groove walls.
Skating comes from the geometry. A pivoted tonearm angles the cartridge inward, the offset that keeps the stylus close to tangent with the groove, so the friction of the groove dragging on the stylus does not pull in line with the pivot. The result is a sideways force toward the spindle, and the stylus presses harder on the inner groove wall than the outer. A linear-tracking arm, which moves the cartridge straight across the record without offset, has no skating force to correct.
Turntables apply the correction with a spring and a numbered dial, a small weight hung on a thread over a lever, or magnets. The force needed is not constant. It rises with tracking force and with groove modulation, so loud passages pull harder than quiet ones, and it changes across the record and with stylus shape. Any fixed setting is a compromise, and makers scale their dials to make the compromise simple.
Anti-skate does not stop skips caused by scratches or dirt, and more is not safer. Too much presses the stylus against the outer wall instead of the inner one, and either error wears the stylus and the groove unevenly.
Common questions
Should anti-skate match tracking force?
As a starting point, yes, on most turntables. Makers usually scale the dial so that the number matching the tracking force in grams is about right: 2 g of force, anti-skate at 2. Some manuals give a different setting, and some older arms have separate scales for conical and elliptical styli; the manual wins. The number is a position on that turntable’s scale, not a measured force, so it does not transfer between turntables.
Is anti-skate necessary?
On a pivoted arm, yes. It is part of setting up the arm, and almost every hi-fi turntable with a pivoted arm has the adjustment. Without it the stylus leans on the inner groove wall, wears unevenly and mistracks sooner than it should. A linear-tracking arm needs none. If your turntable has no adjustment, the maker may have fixed it at the factory, so leave it as it is rather than improvising one.
How do you test anti-skate?
With a test record or your ears, not a blank disc. Friction on a smooth disc with no grooves is not the friction in a groove, so watching the arm drift there misleads. A test record with tracking bands at rising levels shows where distortion starts in each channel; adjust until both break up at about the same band. Without one, play a loud, sibilant track near the end of a side and listen for distortion favoring one speaker.
Does anti-skate affect sound?
Yes, when it is far off, mostly as distortion in one channel. The inner groove wall carries the left channel and the outer wall the right. With too little anti-skate, the stylus loses firm contact with the outer wall first, so loud passages break up in the right channel; with too much, in the left. Near the correct setting, small changes are hard to hear on most records, which is why the maker’s figure is a good place to start.