Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Turntables & vinyl

Spindle

Also called turntable spindle, center spindle

The spindle is the short metal pin at the center of a turntable platter. The record’s center hole fits over it, which keeps the groove centered under the stylus. On many decks it is the top of the platter bearing’s shaft.

A record’s center hole is specified at about 7.24 mm, and the spindle is made a fraction smaller, so the record drops on with slight resistance and no rattle. Any play shows up as off-center playing: the groove swings toward and away from the stylus once a revolution, and the pitch wavers with it, most audibly on long piano notes.

Because the spindle is often the bearing shaft itself, a bent one tilts the whole platter and shows as a wobble at the rim. Record weights and clamps rely on it too: a weight sits over the spindle, and a clamp grips it to hold the record down.

Common questions

What is a 45 adapter?

It is a small insert that lets a turntable play seven-inch singles pressed with the large center hole, 1½ inches across, instead of the small one. The big hole suited jukeboxes and record changers. The adapter is either a puck that slips over the spindle or a plastic spider that clicks into the record’s hole and stays there. Many turntables include one; they cost little and disappear readily.

Do record weights work?

They do two modest things. A weight or clamp presses the record against the mat, which flattens a mild dish warp and couples the vinyl to the platter so it rings less. It does nothing for a warp at the edge, which needs an outer ring or flattening. Check the deck first: a heavy weight adds load to the bearing and can upset a sprung sub-chassis, and some makers advise against using one.

Why won’t a record fit on the spindle?

Usually because the pressing left the hole slightly small or rough. Do not force it: pushing down hard can crack the label area and strains the platter bearing. Ease the hole open with a few turns of a record hole reamer, or carefully with a fine round file, trying it often. A record that needs a little pressure to go on is fine, and it will center better than a loose one.

Should you oil a turntable spindle?

Not the part you can see. Above the platter the spindle only needs to be clean; oil there ends up in record center holes and on labels. What people usually mean is the bearing below, where the spindle’s shaft runs. Follow the maker’s manual: some bearings are sealed, and others take a few drops of a specified oil with the platter removed. A dry bearing tends to rumble or squeak.

Related terms