Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Turntables & vinyl

Platter

Also called turntable platter, record platter

The platter is the heavy disc on a turntable that the record sits on and the motor turns at 33⅓ or 45 rpm. Its mass, the bearing beneath it and the mat on top all affect how steadily and quietly it spins.

A platter turns on a bearing: a vertical shaft running in an oiled well, with a hardened ball or a thrust pad at the bottom. On many decks the top of that shaft is the spindle the record fits over. On a belt drive deck the belt runs either round the platter’s outer rim or round a smaller sub-platter hidden underneath, with the main platter set on top; on a direct drive deck the platter sits on the motor itself.

Mass is the main design lever. A heavy platter behaves like a flywheel, so the drag of the stylus in loud grooves and the small pulses of the motor change its speed less. Weights run from well under a kilogram on budget decks to many kilograms on high-end ones, and a heavier platter needs a stronger bearing and takes longer to reach speed. Material is chosen for how it rings as much as for its weight, and it decides the mat: die-cast aluminum usually wears rubber or felt, glass usually felt, and acrylic is often played bare.

To take a platter off, remove the mat, slip any belt off the motor pulley, and lift it straight up; some decks hold it with a clip or washer on the spindle, which comes off first. Rows of dots or bars round the rim of some platters are a strobe: lit by the deck’s strobe lamp, or a lamp running on mains power, they appear to stand still when the speed is right.

Common questions

Do you need a turntable mat?

Usually yes, if the platter came with one, because the deck was designed and its arm height set with that mat in place. The mat supports the record evenly, damps ringing in a metal or glass platter and stops the vinyl sliding on a hard surface. A platter sold bare is meant to be played bare. A replacement mat much thicker or thinner than the original can call for resetting the tonearm height.

What is the best turntable platter material?

No single material wins. Aluminum is stiff and easy to make heavy, but rings like a bell unless damped. Acrylic and other plastics ring less, so they need less help from a mat. Glass, MDF and steel appear too, and high-end decks sometimes bond layers of different materials so each damps the other. How well a platter is machined, balanced and supported matters more than what it is made of.

What is the difference between a platter mat and a slipmat?

A platter mat holds the record; a slipmat lets it slide. DJs use slipmats, thin felt discs often paired with a slippery sheet underneath, so they can hold a record still or scratch with it while the platter keeps turning. Home listening has no use for that slip, so listening mats in rubber, cork, acrylic or thicker felt are chosen to grip the record and damp it.

Why is my turntable platter wobbling?

Check the record first: a warped disc on a true platter looks exactly like a wobbling platter. If the bare platter still rises and falls at the rim, lift it off and reseat it, check nothing is caught underneath, and clean the spindle and bearing well. A bent spindle or a worn bearing needs a replacement part from the maker. Slight wobble on a budget deck is common; a large one disturbs the stylus.

Related terms