Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Turntables & vinyl

Tracking force

Also called VTF, vertical tracking force, stylus force

Tracking force is the downward weight of the stylus on the record, measured in grams and set with the tonearm’s counterweight. The cartridge maker specifies it, usually somewhere between 1.5 and 2.5 g for hi-fi cartridges. Set it to the maker’s figure.

The force keeps the stylus in contact with both groove walls while the groove swings it from side to side. A cartridge’s suspension is designed around its specified force: at that figure the cantilever sits at the intended angle and the stylus can follow loud passages without leaving the groove. Makers usually give a range and a recommended value inside it, and the recommended value is the place to start.

Both errors cause harm. Too much force compresses the suspension and wears the stylus and the groove walls faster. Too little is the more common mistake and is not the safe side: the stylus loses contact with the groove wall on loud passages and strikes it on the way back, which sounds like distortion and damages the groove. If unsure, use the recommended value, not the bottom of the range.

Strictly it is a force, and some makers quote it in millinewtons as well as grams; 1 g is about 10 mN, so 18 mN means 1.8 g. Ceramic cartridges in all-in-one players and many DJ cartridges are designed for several grams. A hi-fi cartridge is not, and should never be set to match them. Set the anti-skate after the force, since its setting follows from it.

Common questions

Does tracking force affect sound?

Yes, within limits. Near the bottom of the maker’s range some listeners hear a slightly more open sound, but the cartridge is more likely to mistrack on loud, high-frequency passages, heard as distortion or spitting sibilance, often worst near the end of a side. Near the top it tracks more securely. Adjust in steps of 0.1 g within the published range, listening to a demanding track, and never go outside the range to chase a sound.

How much tracking force is too much?

Anything above the maximum the cartridge maker publishes. A tenth of a gram over will not ruin a record, but it wears the stylus and grooves faster and brings no benefit. Several grams, the force ceramic cartridges use, compresses a hi-fi cartridge’s suspension far beyond its design and risks damaging the cantilever. Coins or weights stuck to the headshell, an old DJ habit, add force no gauge has checked and should not be used on a hi-fi cartridge.

Do I need a stylus force gauge?

Not strictly, but it is one of the most useful inexpensive accessories for a turntable. The counterweight scale is accurate only if the arm was balanced exactly and the scale is calibrated, and on budget decks it can be off by a tenth of a gram or more. A digital gauge reading to 0.01 g confirms the setting in seconds. Measure with the gauge’s platform at the height of a record’s surface, as some gauges are built to sit.

Should I increase tracking force if a record skips?

Only after ruling out the other causes, and only within the maker’s range. Most skips come from a scratch or dirt in the groove, a turntable that is not level, anti-skate set far off or a dirty stylus. If those check out and the cartridge mistracks on many records, raise the force in 0.1 g steps up to the published maximum. If it still skips there, the stylus may be worn or the cartridge may not suit the tonearm.

Related terms