Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Turntables & vinyl

Headshell

Also called head shell

The headshell is the small mount at the front of a tonearm that the cartridge bolts to. Some are part of the arm; others detach with a locking collar, so a cartridge can be swapped by changing the whole headshell.

Most detachable headshells share one bayonet fitting: four pins carry the signal and a threaded collar on the arm locks the headshell in place. It is standard on S-shaped arms, including those on most DJ decks and many direct drive turntables. Many straight arms build the headshell into the arm tube, which saves a joint and a little mass.

The cartridge fixes to the headshell with two screws half an inch (12.7 mm) apart, the standard spacing for most cartridges. Slots for those screws let the cartridge slide forward and back to set overhang during alignment. Seen from the front, the cartridge should sit square in the headshell so the stylus stands upright in the groove. Four thin lead wires with push-on tags join the headshell’s pins to the cartridge’s.

Headshell mass counts toward the arm’s effective mass, which has to suit the cartridge’s compliance; the tonearm entry explains the match. Owners with two cartridges often keep each in its own headshell and swap them in seconds, rebalancing the counterweight and checking tracking force each time.

Common questions

Are turntable headshells universal?

Mostly, for arms that take a detachable headshell. The common bayonet fitting means a headshell from one maker will usually fit another’s S-shaped arm. The catch is geometry: headshells differ in length, offset angle and height, so overhang and arm height may need resetting after a swap. Arms with a built-in headshell take none, and a few arms use their own fittings. Check the arm’s manual before buying.

What is the difference between a headshell and a cartridge?

The cartridge does the work; the headshell holds it. A cartridge contains the stylus, cantilever and generator that turn the groove’s motion into an electrical signal. A headshell is a passive bracket with four wires that attaches the cartridge to the arm. Some products blur the line: cartridges sold ready-mounted on a headshell, and one-piece DJ cartridges whose body plugs straight into the arm’s bayonet.

What are the headshell wire colors?

The usual code is white for left channel positive, blue for left ground, red for right channel positive and green for right ground. Cartridge pins are marked with the same colors or with L, R and plus or minus signs. Swapping left and right reverses the stereo image; swapping positive and ground on one channel puts it out of phase, which thins the bass and blurs the center. Grip the tags, not the wires, when pulling them off.

What do headshell weights do?

They add mass at the front of the arm. The usual reason is balance: with a very light cartridge, the counterweight can run out of travel before the arm floats level, and a small weight on the headshell brings the balance point back within reach. The added mass also lowers the arm and cartridge resonance, which can help a low-compliance cartridge on a light arm. Rebalance and reset tracking force after fitting one.

How do you change a turntable headshell?

Put the stylus guard on, lift the arm onto its rest and steady the arm tube with one hand. Unscrew the locking collar at the front of the arm until the headshell comes free, and pull it straight out. Push the new one in with its pins aligned to the sockets, tighten the collar firmly by hand, then rebalance the arm and set the tracking force again, since a different headshell and cartridge weigh differently.

Related terms