Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Speakers

Bi-wiring

Also called bi-wire, biwiring, bi wiring, bi-wired speakers

Bi-wiring runs two separate pairs of speaker cable from one amplifier channel to a speaker with two sets of terminals, one for its woofer section and one for its tweeter section. Measured differences are small, and listeners disagree about whether it is audible.

A bi-wirable speaker splits its passive crossover into a bass section and a treble section, each with its own pair of terminals, joined at the factory by metal links called jumpers or straps. With the jumpers in place, one cable feeds both. To bi-wire, remove the jumpers and run one cable to the bass terminals and a second to the treble terminals, with both cables connected to the amplifier’s single pair of outputs for that channel.

The argument for it is that the woofer draws large currents and sends energy back down the cable, which on a shared run could modulate the signal reaching the tweeter; separate runs keep the two apart until the amplifier terminals. Calculated for a simple speaker, the differences are small, around a tenth of a decibel with ordinary cable and less with thicker, lower-resistance cable. Listeners disagree about whether they hear it.

Before bi-amping, with two separate amplifier channels feeding the two pairs of terminals, the jumpers must come out: left in, they join the amplifier outputs together and can damage them.

Common questions

Is bi-wiring worth it?

Only if it costs you little. If you already have the cable, or the speakers came with a bi-wire set, trying it is harmless and easy to undo. Buying a second run of expensive cable for it is hard to justify on the numbers, which show changes of around a tenth of a decibel, likely smaller than the effect of moving your head. Spend on placement and amplification before this.

What is the difference between bi-wiring and bi-amping?

Bi-wiring uses one amplifier channel and two cables per speaker; bi-amping uses two amplifier channels per speaker, one for the bass terminals and one for the treble. In passive bi-amping the speaker’s own crossover still splits the signal, and listeners disagree about how much it adds. Active bi-amping moves the crossover ahead of the amplifiers, as in active speakers. Both need the jumpers removed.

How do you connect bi-wire speakers with a single cable?

Leave the jumpers in place and connect the cable to either pair of terminals; electrically it makes little difference, since the jumpers join them. Some owners take positive to one pair and negative to the other, a diagonal arrangement said to balance the path through the jumpers, and any effect is small. Check the jumpers are clean and tight, because a loose link is a more common fault than the choice of pair.

Does bi-wiring change speaker impedance?

No. The amplifier sees the same load whether the speaker is bi-wired or not, because the bass and treble sections are joined at the amplifier terminals either way, by the jumpers or by the two cables. A 4 Ω speaker stays a 4 Ω speaker, and the amplifier needs no different setting. The only change is the small resistance of each cable run, now in series with one section instead of both.

Should you replace bi-wire jumpers with cable?

Only if the originals are flimsy, loose or tarnished. The supplied jumpers are short metal plates or wires, and their resistance is tiny next to the cable run that feeds them. Replacing them with short lengths of speaker cable is cheap, and some owners prefer it. Expensive aftermarket jumpers are the cable argument in miniature. Clean, tight contacts matter more than what the jumper is made of.

Related terms