Step-up transformer
Also called SUT, MC step-up transformer, moving coil transformer
A step-up transformer, or SUT, is a passive box that raises the signal of a low-output moving coil cartridge to the level a moving magnet phono input expects. It needs no power, and its gain is set by the ratio of its windings.
A SUT sits between the turntable and a phono stage set to MM. Inside are two coils of wire on a shared magnetic core. The cartridge drives the primary winding, and the secondary, with more turns, produces a voltage larger by the turns ratio. Power stations use step-up transformers on the same principle to raise voltage for transmission; the audio kind handles less than a millionth of a watt. The gain in decibels is 20 times the logarithm of the ratio: 1:10 gives 20 dB, 1:20 gives 26 dB and 1:30 about 29.5 dB.
The ratio also sets the load the cartridge sees. The phono input’s 47 kΩ is divided by the square of the ratio, so it appears as 470 Ω behind a 1:10 transformer and about 118 Ω behind 1:20. Higher ratios give more gain and a lower load at the same time, which is why a transformer is chosen for a particular MC cartridge and not bought on gain alone.
The alternative is an active MC stage, which gets its gain from transistors or tubes. A transformer adds almost no noise of its own, but its windings can pick up hum from nearby mains transformers, so good ones are shielded and placed away from power supplies, with the turntable’s ground wire connected.
Common questions
Which step-up transformer ratio do I need?
Work from the cartridge’s output and its internal impedance. Aim to bring the output to roughly 3 to 5 mV, typical of a moving magnet cartridge: a 0.3 mV cartridge needs about 1:10 to 1:15, and a 0.2 mV one nearer 1:20. Then check the load, 47 kΩ divided by the ratio squared, against the cartridge maker’s recommended load. Transformer makers list the range of cartridge impedances each model suits.
Can you use a step-up transformer with a moving magnet cartridge?
No. A moving magnet cartridge already gives about 5 mV, and a 1:10 transformer would send about 50 mV to an input whose nominal level is a tenth of that, which can overload it. The cartridge would also see a load of a few hundred ohms where it needs 47 kΩ, which dulls the treble. Some boxes have a bypass switch for this; set it to bypass, or MM, for a moving magnet, or take it out of the chain.
Is a step-up transformer better than an MC phono stage?
Neither wins on measurement alone. A transformer needs no power and adds almost no noise, but its gain and loading are fixed by its ratio, it can pick up hum, and good ones cost as much as a decent active stage. An active MC stage offers adjustable gain and loading in one box, at the price of some hiss from its first amplifying devices. Listeners disagree about which sounds better.
Does a step-up transformer increase current?
No, it reduces it. A transformer raises voltage and lowers current by the same ratio, so the power out can never exceed the power in, and a little is always lost in the windings and core. A 1:10 transformer gives ten times the voltage and at most a tenth of the current. A phono input draws almost no current, so voltage is what counts there, and the trade costs nothing useful.