Presence
Also called presence region, presence range
Presence is the region from roughly 2 to 5 kHz, where the upper mids meet the lower treble. It carries the attack of notes and the clarity of voices: enough sounds close and clear, too little distant, too much shouty or harsh.
The ear is at its most sensitive here, helped by the ear canal’s own resonance near 3 kHz, so small changes in presence are easier to hear than the same changes in the bass. A natural sound arrives at the eardrum with a lift in this region, which is why every headphone target rises through it. A headphone that falls short of that rise sounds veiled; one that overshoots sounds forward, and can win a quick comparison, then tire you by the end of the album.
Too much presence makes voices push ahead of the band, electric guitars grate and fatigue set in within an hour. Too little sets singers back behind the drums, the usual shape of a V-shaped tuning. The region sits just below the sibilance band of about 5 to 10 kHz, and a product can have one fault without the other: shout lives in presence, hiss above it.
Reviewers also use presence loosely for the sense that a performer is in the room with you. That is a listening impression made of many things, including imaging and dynamics; on this page the word means the frequency region, the one that consonants, plucks and stick hits depend on.
Common questions
Why do some headphones sound shouty?
Too much energy in the presence region, usually between 2 and 4 kHz, relative to the bass and treble around it. Voices and guitars jump forward and loud passages grate. It is common in budget IEMs tuned to sound clear in a quick listen. With an equalizer, a broad cut of 2 to 3 dB near 3 kHz usually fixes it; lowering the volume helps too, since the effect grows with level.
What does the presence knob on a guitar amp do?
It raises or lowers the upper mids and treble in the power amplifier section, after the tone stack. On many tube amps it works by reducing the negative feedback at high frequencies, so it sounds different from the treble control: more bite and edge, less fizz. It shares the name with the frequency region because it works on roughly the same range, the part that helps a guitar cut through a band.
What is a presence boost on a microphone?
A built-in lift of a few decibels in the presence region that makes a voice clearer and helps it cut through a mix. Many vocal microphones have one as part of their response, and some, the Shure SM7B among them, have a switch to turn it on. It works the same way an equalizer boost would, so a voice that is already bright or sibilant usually sounds better with it off.
Is presence the same as the upper midrange?
Nearly. The upper mids are usually given as about 2 to 4 kHz, and presence as about 2 to 5 kHz, so presence also takes in the lowest part of the treble. Boundaries differ from writer to writer and none is official. In practice both terms describe the same complaint or praise: how forward voices and attacks are relative to the rest of the music.