Your rig deserves a home. Catalog your gear and get your own A-number. Free, always.

Turntables & vinyl

Cueing lever

Also called cue lever, tonearm lift, tonearm lifter, cue lift, arm lift

The cueing lever raises and lowers the tonearm slowly, so the stylus lands in the groove gently instead of being dropped by hand. Raise the lever, move the arm over the record, then lower it; a damped mechanism controls the descent.

The lever works a small platform, or lift bar, under the arm tube. Raised, it holds the arm clear of the record; lowered, it sinks through a film of thick silicone fluid or grease that slows the fall, and the arm settles until the stylus rests in the groove. Lifting partway through a side and lowering again is the cleanest way to pause, or to skip to the next track by eye.

Many arms let you set the lift height with a small screw. A few millimeters of clearance above the record is enough; too little and the stylus can drag across a warped record while the arm is moved.

Automatic and semi-automatic decks drive the same lift from the motor at the end of a side. Some budget decks have no cue lever at all, and lowering by hand works, but a steady hand is then the only damping.

Common questions

Why is my tonearm not lowering?

Usually the arm is out of balance or the lift is set too high. The counterweight may sit so far back that the arm floats; rebalance it and set the tracking force. A lift bar set too high never drops below the arm tube; its height screw fixes that. If the arm creeps down slowly or sticks partway, the damping fluid has thickened with age, and fresh fluid or a service by a technician cures it.

Why does my cue lever drop the arm too fast?

The damping fluid has leaked away or broken down. The lift sinks through viscous silicone fluid or grease, and without it the arm falls almost freely, which risks chipping the stylus or bending the cantilever. Replacing the fluid with cueing damping oil of the right viscosity, sold in small tubes for the purpose, restores the slow descent. Until it is fixed, steady the arm by its finger lift and lower it by hand.

Can you add a cue lever to a turntable?

Often, yes. Add-on cue lifts are sold for decks that came without one; they fix to the plinth beside the arm and have their own damped platform. An arm that had a lift and lost it can usually take a replacement part from the maker or a parts supplier. Fit it so the platform sits under the arm tube, raises the stylus a few millimeters and drops fully clear when lowered.

Related terms