Open-back Bluetooth headphones from Grado, released in 2018, with aptX, 15 hours of battery life and a 3.5mm cable for wired use. An open-back on the bus shares the playlist with the whole top deck.
Headphones · Open-back · Dynamic · 32 Ω · 99.8 dB/mW
No members own one yet. Own one? Add it to your collection
Released
2018
discontinued
Impedance
32Ω
99.8 dB/mW
Rating
—
be the first to rate
Owners
0
be the first
Measured
2
frequency curves
MSRP
$249
no live price today
About
They are an on-ear design, and inside are Grado's own drivers, the same ones used in its wired headphone line. A built-in microphone handles hands-free calls, and charging is over micro-USB.
Against a common listening target, the bass (60–250 Hz) sits 5.4 dB above it and the air band (10–20 kHz) 5.3 dB above, while the sub-bass (20–60 Hz) and upper mids (2–5 kHz) stay within 1 dB. They weigh 170 g and were listed at $249.
Specs
The technical bits
Sound
32Ω
99.8 dB/mW
Driver Type
Driver Size
44mm
20Hz-20kHz
Weight
170g
Design
Yes
Cable
Detachable
What to pair it with
All of these have enough power for the Grado GW100 (32 Ω, 99.8 dB/mW). 100 dB needs about 1 mW; with our 10 dB reserve, about 10 mW.

FiiO
K19
Rated 2.3 W SE, 8 W balanced into 32 Ω.
6.35 mm and 4.4 mm balanced.

Singxer
SA-1
Rated 5.5 W balanced into 32 Ω.
One balanced output.

FiiO
K17
Rated 1.85 W SE, 4 W balanced into 32 Ω.
6.35 mm and 4.4 mm balanced.

JDS Labs
Element IV
Rated 3.2 W into 32 Ω.
One 6.35 mm output.
We compare the voltage these headphones need to reach 100 dB with what each amp is rated to deliver, and look for a 10 dB reserve on top. The ratings come from the makers' own spec sheets. This is about power only. It says nothing about how the pair sounds, and it doesn't cover amp output impedance. Makers rate power at their own distortion limit, often 1% THD+N, so clean power can be lower. Power is shown single-ended (SE) and balanced where an amp has both. Figures at different loads are not directly comparable, so we compare voltage. The target is our policy, not a physical limit.
Frequency-response effects matter most for low-impedance or multi-driver in-ear monitors, and sensitivity is a single-frequency figure.
Grado GW100: 32 Ω, 99.8 dB/mW (source)
FiiO K19
Singxer SA-1
FiiO K17
Compare
Where to buy

Grado GW100
Headphones
As an Amazon Associate audiophila. earns from qualifying purchases.
We like to keep the amps flowing. We could run ads, but we prefer affiliate links—they're what we'd click anyway to dig deeper. Thanks for the support!
JDS Labs Element IV
audiophila. community ranks
Current ownership and wishlists, ranked within each category. These measure community participation, not sales or sound quality.
Snapshot: 2026-11-16 UTC · All regions · Method v1
Not enough community data to publish ranks yet.
Not enough community data to publish ranks yet.
History begins with the first daily snapshot. A chart appears after two observations.
Each member counts once per model, and once per brand in a category. Previous ownership is excluded. Suspended members and unapproved catalog entries are excluded. Variants with a parent model are excluded. An entry needs at least three members, and its category needs three eligible entries, before a rank is shown. Ties share a rank; the next position skips the tied entries. Each denominator is the eligible comparison group on that day. Brand-page model positions remain category ranks, not ranks across unrelated gear. History records observed daily positions, with gaps preserved. Up to ten entries per category and metric are displayed.