The Nagra Model I is a closed-back planar-magnetic monitoring headphone developed with Audeze. Its 106 mm transducers, 70-ohm impedance and rugged carrying case suit recording work. At 612 g, the word portable describes the itinerary more comfortably than the weight.
Headphones · Closed-back · Planar magnetic · 70 Ω · 101 dB/mW
No members own one yet. Own one? Add it to your collection
Driver Size
106 mm
Impedance
70Ω
101 dB/mW
Rating
—
be the first to rate
Owners
0
be the first
Weight
612 g
About
Developed through a collaboration between Nagra and Audeze, the Model I uses 106 mm planar transducers, a proprietary magnet array and a closed over-ear design. It is intended for monitoring with portable recording equipment where carrying loudspeakers is impractical. A protective case is supplied.
Nagra specifies 70-ohm impedance, 101 dB sensitivity for 1 mW at the drum reference point and a 20 Hz–45 kHz frequency range. Published weight is 612 g. The recommended power figure is above 250 mW, so amplifier capability deserves attention even when the recorder itself is small. This entry follows Nagra’s own Model I specification rather than substituting a similar-looking Audeze model.
Specs
The technical bits
What to pair it with
All of these have enough power for the Nagra Model I (70 Ω, 101 dB/mW). 100 dB needs about 0.79 mW; with our 10 dB reserve, about 7.9 mW.

FiiO
K19
Rated 2.3 W SE, 8 W balanced into 32 Ω.
6.35 mm and 4.4 mm balanced.

Singxer
SA-1
Rated 3.1 W balanced into 68 Ω.
70Ω
101 dB/mW
Driver Type
Driver Size
106 mm
20 Hz–45 kHz (manufacturer specification)
Weight
612g
Design
No
One balanced output.

Violectric
HPA V222
Rated 3.4 W balanced into 50 Ω.
One Headphone outputs (balanced and 6.3 mm) output.

FiiO
K17
Rated 1.85 W SE, 4 W balanced into 32 Ω.
6.35 mm and 4.4 mm balanced.
We compare the voltage these headphones need to reach 100 dB with what each amp is rated to deliver, and look for a 10 dB reserve on top. The ratings come from the makers' own spec sheets. This is about power only. It says nothing about how the pair sounds, and it doesn't cover amp output impedance. Makers rate power at their own distortion limit, often 1% THD+N, so clean power can be lower. Power is shown single-ended (SE) and balanced where an amp has both. Figures at different loads are not directly comparable, so we compare voltage. The target is our policy, not a physical limit.
Frequency-response effects matter most for low-impedance or multi-driver in-ear monitors, and sensitivity is a single-frequency figure.
Nagra Model I: 70 Ω, 101 dB/mW (source)
FiiO K19
Singxer SA-1
Violectric HPA V222
FiiO K17
audiophila. community ranks
Current ownership and wishlists, ranked within each category. These measure community participation, not sales or sound quality.
Snapshot: 2026-11-16 UTC · All regions · Method v1
Not enough community data to publish ranks yet.
Not enough community data to publish ranks yet.
History begins with the first daily snapshot. A chart appears after two observations.
Each member counts once per model, and once per brand in a category. Previous ownership is excluded. Suspended members and unapproved catalog entries are excluded. Variants with a parent model are excluded. An entry needs at least three members, and its category needs three eligible entries, before a rank is shown. Ties share a rank; the next position skips the tied entries. Each denominator is the eligible comparison group on that day. Brand-page model positions remain category ranks, not ranks across unrelated gear. History records observed daily positions, with gaps preserved. Up to ten entries per category and metric are displayed.